I have a machine that has the following devices; it works fine most of
the time, unless I need to do an fsck -p or dump and restore. Then I get
bha0 timed out, and then timed out AGAIN... Any clues?

christos

bha0 at pci0 dev 13 function 0: BusLogic 9xxC SCSI
bha0: interrupting at irq 10
bha0: model BT-946C, firmware 4.25J
bha0: sync, parity
bha0 targ 0: sync, offset 15, period 100nsec
bha0 targ 1: sync, offset 15, period 100nsec
bha0 targ 2: sync, offset 15, period 100nsec
bha0 targ 3: sync, offset 15, period 100nsec
bha0 targ 4: sync, offset 8, period 200nsec
scsibus0 at bha0: 8 targets
sd0 at scsibus0 targ 0 lun 0: <SEAGATE, ST51080N, 0896> SCSI2 0/direct fixed
sd0: 1030MB, 4826 cyl, 4 head, 109 sec, 512 bytes/sec
sd1 at scsibus0 targ 1 lun 0: <CONNER, CFP2105S  2.14GB, 172A> SCSI2 0/direct fixed
sd1: 2048MB, 3940 cyl, 10 head, 106 sec, 512 bytes/sec
sd2 at scsibus0 targ 2 lun 0: <SEAGATE, ST15150N, 0020> SCSI2 0/direct fixed
sd2: 4095MB, 3712 cyl, 21 head, 107 sec, 512 bytes/sec
sd3 at scsibus0 targ 3 lun 0: <SEAGATE, ST19171N, 0023> SCSI2 0/direct fixed
sd3: 8683MB, 5268 cyl, 20 head, 168 sec, 512 bytes/sec
st0 at scsibus0 targ 4 lun 0: <HP, HP35480A, 1109> SCSI2 1/sequential removable
st0: density code 0x13, variable blocks, write-enabled