When trying to boot the NetBSD INSTADP install kernel on the above machin=
e, it appears to recognize the onboard ethernet controller but fails to r=
ecoginize the SCSI controller and disks.  It gives the following message:=


NetBSD 1.1 (INSTADP) #0: Fri Nov 24 06:06:48 PST 1995
    root@boojum.piermont.com:/usr/src/sys/arch/i386/compile/INSTADP
CPU: Pentium (GenuineIntel 586-class CPU)
real mem  =3D 16384000
avail mem =3D 14270464
using 225 buffers containing 921600 bytes of memory
isa0 (root)
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com2 at isa0 port 0x3e8-0x3ef irq 5: ns16550a, working fifo
lpt0 at isa0 port 0x378-0x37f irq 7
ie0: unknown AT&T board type code 15
npx0 at isa0 port 0xf0-0xff: using exception 16
WARNING: Pentium FDIV bug detected!
pc0 at isa0 port 0x60-0x6f irq 1: color
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
root device eisa not configured
pci0 (root): configuration mode 2
***
pci0 bus 0 device 0: unknown vendor/product: 0x8086/0x04a3 (class: bridge=
, subcl
***
ass: host, revision: 0x03) not configured
le0 at pci0 bus 0 device 11: address 00:80:5f:78:20:5b, 8 receive buffers=
, 2 tra
nsmit buffers
le0: type PCnet-PCI
pci_map_int: pin B mapped to line 10
***
pci0 bus 0 device 12: unknown vendor/product: 0x1022/0x2020 (class: mass =
storage
, subclass: SCSI, revision: 0x02) not configured

pci0 bus 0 device 13: unknown vendor/product: 0x102b/0x0518 (class: displ=
ay, sub
class: VGA, revision: 0x00) not configured

pci0 bus 0 device 15: unknown vendor/product: 0x0e11/0x0001 (class: bridg=
e, subc
lass: EISA, revision: 0x03) not configured
***
biomask 40 netmask 400 ttymask 32
changing root device to fd0a
WARNING: no swap space found


Any ideas on this problem?


p.s. should I be worried about the following? :)

ass: host, revision: 0x03) not configured