Re: installation freezed

["lepingouin.tux" <lepingouin.tux%laposte.net@localhost>]

Hubert Feyrer wrote:

> [CC:d port-i386]
>
>
> On Wed, 27 Jul 2005, lepingouin.tux wrote:
>
> > Hum, sorry, it just because I use a pc104 card and it's an embedded 
> > computer !
> > but i have no error message, just (in sysinst yes) a freeze message. 
> > And I dont know if my disk is reconized properly (how to know that ?)!
>
>
> Press ^C and type "dmesg" to see the boot messages, there should be a 
> "wd0" or so in there (if you use a IDE disk; "sd0" for SCSI). Use 
> "fdisk wd0" and "disklabel wd0" to see the MBR and NetBSD partition 
> tables.
>
>
>  - Hubert
I think my disk is ok, I have this message :

wd0 at atabus0 drive 0: <maxtor 72004 AP>
wd0: drive supports 32-sector PIO transferts, LBA addressing
wd0: 1916 MB, 3893 cyl, 16 head, 63 sec, 512 bytes/sec x 3924360 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2
wd0(geodeide0:0:0): using PIO mode 4, DMA mode 2(using DMA data transferts)

!!!

martoni