Hi,

I tired...

ipconfig_interface="de0"
dhclient=YES
dh_flags=""

and that did not work.

When I boot the kernel shows de0, it's interrupt, etc. It even says...

de0: enabling 10baseT port

So I am pretty sure the systems sees the NIC.

Additionally, these lines are printed out...

add net 127.0.0.0 gateway 127.0.0.1
add net fe80 gateway ::1
add net fec0 gateway ::1
add net ::224.0.0.0 gateway ::1
add net ::127.0.0.0 gateway ::1
add net ::0.0.0.0 gateway ::1
add net 2002:e000 gateway ::1
add net 2002:7f00 gateway ::1
add net 2002:0000 gateway ::1
add net 2002:ff00 gateway ::1
add net 0.0.0.0 gateway ::1
IPv6 mode: host

Does this look correct? Is the IPv6 mode correct?

Thanks.

S


--- "IvanK." <chepati@yahoo.com> wrote:
> Hey there,
> 
> get rid of the defaultrouter line (DHCP sets this up automatically)
> and where it says ipconfig_interface="DHCP" change that to say
> ipconfig_interface="de0" for a Tulip based NIC, or ne0 for a N2k NIC.
>  Do 
> ifconfig -ua, and decide which interface will be connected to the
> outside 
> line, ie which network card will be the DHCP-configured interface. 
> Then use 
> that interface in ipconfig_interface="xxN".
> 
> Hope that helps,
> chepati
> 
> On Sunday 14 October 2001 12:29 pm, S Lafredo wrote:
> > In my rc.conf I have added...
> >
> > defaultrouter=192.168.1.1
> > ipconfig_interface="DHCP"
> > dhclient=YES
> > dh_flags=""
> 
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
> 


__________________________________________________
Do You Yahoo!?
Make a great connection at Yahoo! Personals.
http://personals.yahoo.com