On Sat, Apr 29, 2000 at 03:45:31PM +1000, Simon J. Gerraty wrote:
> A data point in case it is of interest.  I just booted a 1.4X sparc/MP
> kernel (output below).
> 
> The same kernel config (sans MULTIPROCESSOR and DIAGNOSTIC) compiled
> at the same time, booted and is working ok.
> 
> --sjg


this appears to be a hypersparc-specific problem,
I see the same problem with my sparc10 with ross cpus.
here's the boot output from a sparc20 with supersparc cpus:


NetBSD 1.4X (CHUQ.MP) #0: Fri Apr 28 07:39:28 PDT 2000
    chs@pc.chuq.com:/home/chs/netbsd/src/sys/arch/sparc/compile/CHUQ.MP
total memory = 64712 KB
avail memory = 56304 KB
using 834 buffers containing 3336 KB of memory
bootpath: /iommu@f,e0000000/sbus@f,e0001000/ledma@f,400010/le@f,c00000
mainbus0 (root): SUNW,SPARCstation-20
cpu0 at mainbus0: mid 8: TMS390Z50 v0 or TMS390Z55 @ 75 MHz, on-chip FPU
cpu0: physical 20K instruction (64 b/l), 16K data (32 b/l), 1024K external (32 b/l): cache enabled
cpu1 at mainbus0: mid 10: TMS390Z50 v0 or TMS390Z55 @ 75 MHz, on-chip FPU
cpu1: physical 20K instruction (64 b/l), 16K data (32 b/l), 1024K external (32 b/l): cache enabled
obio0 at mainbus0
clock0 at obio0 slot 0 offset 0x200000: mk48t08 (eeprom)
timer0 at obio0 slot 0 offset 0x300000 delay constant 35
zs0 at obio0 slot 0 offset 0x100000 level 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at obio0 slot 0 offset 0x0 level 12 softpri 6
kbd0 at zs1 channel 0
ms0 at zs1 channel 1
fdc0 at obio0 slot 0 offset 0x700000 level 11: no drives attached
auxreg0 at obio0 slot 0 offset 0x800000
power0 at obio0 slot 0 offset 0xa01000 level 2
iommu0 at mainbus0 ioaddr 0xe0000000: version 0x3/0x1, page-size 4096, range 64MB
sbus0 at iommu0: clock = 25 MHz
dma0 at sbus0 slot 15 offset 0x400000: rev 2
esp0 at dma0 slot 15 offset 0x800000 level 4: ESP200, 40MHz, SCSI ID 7
scsibus0 at esp0: 8 targets, 8 luns per target
ledma0 at sbus0 slot 15 offset 0x400010: rev 2
le0 at ledma0 slot 15 offset 0xc00000 level 6: address 08:00:20:7c:2f:37
le0: 8 receive buffers, 2 transmit buffers
bpp0 at sbus0 slot 15 offset 0x4800000 level 2 (ipl 3): rev 2
SUNW,DBRIe at sbus0 slot 14 offset 0x10000 level 9 not configured
Qlogic ISP Driver, NetBSD (sbus) Platform Version 0.997 Core Version 1.12
isp0 at sbus0 slot 1 offset 0x10000 level 3 (ipl 5) for QLGC,isp
isp0: mbox cmd 8 failed with INVALID_COMMAND
isp0: Differential Mode
isp0: Board Revision 1020A, loaded F/W Revision 1.31.0
isp0: 1040 max I/O commands supported
isp0: driver initiated bus reset of bus 0
scsibus1 at isp0: 16 targets, 8 luns per target
hme0 at sbus0 slot 3 offset 0x8c00000 level 4 (ipl 7): address 08:00:20:7c:2f:37
nsphy0 at hme0 phy 1: DP83840 10/100 media interface, rev. 0
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
SUNW,fas at sbus0 slot 3 offset 0x8800000 level 3 (ipl 5) not configured
eccmemctl0 at mainbus0: version 0x0/0x2
scsibus0: waiting 2 seconds for devices to settle...
probe(esp0:1:0): max sync rate 10.00MB/s
sd1 at scsibus0 target 1 lun 0: <SEAGATE, ST32430W SUN2.1G, 0508> SCSI2 0/direct fixed
sd1: 2049 MB, 3992 cyl, 9 head, 116 sec, 512 bytes/sect x 4197405 sectors
probe(esp0:3:0): max sync rate 10.00MB/s
sd3 at scsibus0 target 3 lun 0: <SEAGATE, ST32430W SUN2.1G, 0508> SCSI2 0/direct fixed
sd3: 2049 MB, 3992 cyl, 9 head, 116 sec, 512 bytes/sect x 4197405 sectors
probe(esp0:6:0): max sync rate 4.23MB/s
cd0 at scsibus0 target 6 lun 0: <TOSHIBA, XM-4101TASUNSLCD, 3424> SCSI2 5/cdrom removable
scsibus1: waiting 2 seconds for devices to settle...
root on le0
mountroot: trying coda...
mountroot: trying msdos...
mountroot: trying cd9660...
mountroot: trying lfs...
mountroot: trying nfs...
nfs_boot: trying RARP (and RPC/bootparam)
nfs_boot: client_addr=x.x.x.x (RARP from x.x.x.x)
nfs_boot: server_addr=x.x.x.x
nfs_boot: hostname=sparc20
nfs_boot: gateway=x.x.x.x
nfs_boot: my_mask=255.255.255.0
root on chuq:/home/export/sparc-netbsd
root time: 0x390b2d0f
root file system type: nfs
init: copying out path `/sbin/init' 11
swapctl: /dev/sd0b: Device not configured
Automatic boot in progress: starting file system checks.
setting tty flags
starting network
hostname: sparc4.chuq.com
default              router               done
configuring network interfaces: le0.
add net default: gateway router
adding interface aliases:
WARNING:  no swap space configured!
starting rpc daemons: portmap.
starting nfs daemons:.
checking quotas: done.
building databases...
clearing /tmp
standard daemons: cron.
starting network daemons: inetd.
starting local daemons:.
Sat Apr 29 11:31:57 PDT 2000
Apr 29 11:31:57 init: kernel security level changed from 0 to 1

NetBSD/sparc (sparc20.chuq.com) (console)

login: 



-Chuck