Subject: Re: print/pdflib build failure on MacOS X 10.3.4
To: Ronald van der Pol <Ronald.vanderPol@rvdp.org>
From: Mark E. Perkins <firstname.lastname@example.org>
Date: 06/16/2004 19:03:08
On 6/16/04 8:31 AM, Ronald van der Pol wrote:
> On Wed, Jun 16, 2004 at 12:04:27 +0200, Ronald van der Pol wrote:
>>(I you get that far, the gnuplot build will fail :-( I haven't looked at
> Using gnuplot 4.0.0 (patches are in PR#25450) works fine on MacOSX 10.3.4.
Yesterday I managed to rescue the pdflib build by linking Files.h into
work/.buildlink/include (as noted in my original post), and also linking
its parent directory into work/.buildlink/include as CarbonCore. CarbonCore
is the directory shown in #include statements in Files.h that were causing
the next layer of problems. I'll look back in CVS and see what else I can
sort out about this.
But then the build for gnuplot failed (as you note) and I haven't tracked
that down yet, either. Will apply the 4.0.0 patches and go from there.
Thanks for the tip.