Hi

I can't seem to get a sparc bulk build to finish :(  It will make it 3/4
of the way through or so and then ends up quitting.  It stops in a
different place each time, but it always looks like this:

[snip]
sparc> ===> Installing for ap-Embperl-1.2.0
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/auto/HTML/Embperl/Embperl.so
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/auto/HTML/Embperl/Embperl.bs
sparc> Files found in blib/arch: installing files in blib/lib into
architecture dependent library tree
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/embpcgi.test.pl
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/Embperl.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/Changes.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/Faq.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/FeaturesD.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/Embperl.pm
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/embpcgi.pl
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/Intro.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/embpexec.pl
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/INSTALL.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/IntroD.pod
sparc> Installing
/usr/pkg/lib/perl5/site_perl/5.6.0/sparc-netbsd/HTML/EmbperlD.pod
sparc> Installing Build finished.  Removing all installed packages left
over from build...
pkg_delete -r apache-1.3.19nb1
pkg_delete -r libperl-5.6.0nb2
[snip]

its like the 'make' just stopped in the middle somewhere.  Anyone else see
anything like this?  I haven't had any problems before the last few weeks
and its only on sparc (alpha is fine).  Its running a 1.5 userland and a
somewhat more recent 1.5 branch kernel.


-Dan