Hi there, I got a BUFFALO WLI-U2-KG54-AI, "succesfully" attached but 
when I try to assign an address, either manually or via dhclient it goes 
on timeout, as shown below.
It's an USB adapter even if it's called ral*.
Here's the full dmesg output:


uhidev1 at uhub1 port 1 configuration 1 interface 0
uhidev1: BUFFALO WLI-U2-KG54-AI, rev 2.00/1.15, addr 2, iclass 3/1
uhid at uhidev1 not configured
uhidev1: at uhub1 port 1 (addr 2) disconnected
uhidev1 detached
ral0 at uhub1 port 1
ral0: BUFFALO WLI-U2-KG54-AI, rev 2.00/1.15, addr 2
ral0: MAC/BBP RT2570 (rev 0x03), RF RT2526, address 00:0d:0b:62:a5:f0
ral0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ral0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 
24Mbps 36Mbps 48Mbps 54Mbps
ral0: timeout waiting for BBP/RF to wakeup
ral0: timeout waiting for BBP/RF to wakeup


# ifconfig ral0 inet 192.168.1.15
ifconfig: SIOCAIFADDR: Input/output error


I'm on a 3.99.8 macppc machine, I've tried also on a 3.99.8 GENERIC i386 
kernel and the results are the same.
The only thing I've done was adding the ral(4) driver line to the config 
files.
Am I missing something?
I did not found anything related to my problem via google.
The other parameters are fully configurable with ifconfig(8).
Please to/cc me because I'm not subscribed to this list.
Thank you.

My best regards
-- 
	dixie

I'm here only to improve my Inglisc.