Hi,

i'm using the ural(4) driver from current tree

/*      $NetBSD: if_ural.c,v 1.5 2005/07/12 12:51:03 drochner Exp $ */

it works like a charm for a classic use, but i found that strangely, scan 
mode doesn't work, say: 
wiconfig ural0 -D will put the link to a "no network" state and print :

scanning .............wiconfig: ioctl: Operation now in progress

here is the card i use :

ural0 at uhub0 port 1
ural0: ASUS 802.11g WLAN Drive, rev 2.00/0.01, addr 2
ural0: MAC/BBP RT2570 (rev 0x03), RF RT2526, address 00:11:d8:dc:10:d3
ural0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ural0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 
24Mbps 36Mbps 48Mbps 54Mbps

is this a known problem ?

Thanks

-------------------------
iMil <imil@home.imil.net>                                                 _
       http://gcu-squad.org                          ASCII ribbon campaign ( )
                                                      - against HTML email  X
                                                                  & vCards / \