Subject: Re: pc164/ncr scsi problems
To: Darren Reed <firstname.lastname@example.org>
From: Brett Lymn <email@example.com>
Date: 08/29/1999 17:00:11
According to Darren Reed:
>I'll try turning of SYNC, but I don't like having to do that.
I didn't like doing it either but in my case I was just trying to get
data off the old disk so I lived with it :-/ What I did was just turn
off sync negotiation on the old disk I had on the chain which seemed
to do the trick.
>For reference, this drive was working, synchronous, under SunOS 4.1.4
>in a Sparc LX (Fast SCSI, just not Ultra) at 10Mbit/s.
Also for reference, my disks were working fine _for_years_ until I put
the IBM DCHS09Z and Plextor 820T on the chain then things got tetchy.
All the cables were the same ones I have been using for ages (twisted
pair ribbon cable FWIW). I could sometimes boot up and sometimes not,
other times I could get things running by power cycling the old disk
during boot, I did try juggling around the terminating device to no
avail. The old disks were a Seagate 1G and a Fujitsu 2.9G. IIRC the
Fuji was the one that gave me the grief. I run fast, narrow scsi.
Brett Lymn, Computer Systems Administrator, British Aerospace Australia