Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?

To: Jason Thorpe <thorpej%me.com@localhost>, Manuel Bouyer <bouyer%antioche.eu.org@localhost>
Subject: Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
From: Dave McGuire <mcguire%neurotica.com@localhost>
Date: Fri, 18 May 2018 12:04:40 -0400

On 05/18/2018 12:01 PM, Jason Thorpe wrote:
> So, no comments on the new interface at all?

  My ownly comment is a word of encouragement.  That's a damn nice piece
of work, there.

              -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA

References:
- GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
  - From: Jason Thorpe
- Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
  - From: Manuel Bouyer
- Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
  - From: Jason Thorpe
- Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
  - From: Jason Thorpe
- Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
  - From: Jason Thorpe

Prev by Date: Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
Next by Date: ds18b20 Temperature Sensor
Previous by Thread: Re: GPIO subsystem and interrupts -- no way to do rising & falling edge on same pin?
Next by Thread: ds18b20 Temperature Sensor
Indexes:

Home | Main Index | Thread Index | Old Index