[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
Re: zaurus models and peripherals supported
On Sat, 20 Jan 2007, Theo Borm wrote:
Date: Sat, 20 Jan 2007 00:03:38 +0100
From: Theo Borm <theo_pzrs%borm.org@localhost>
Subject: zaurus models and peripherals supported
Let me begin by congratulating the people who made this port happen.
I've been looking for a *reasonably current* handheld device supported
by NetBSD for quite some time, so thank you for all the hard work you've
Thank NONAKA Kirihimo and Peter Postma :)
seems to be the only difference, but since I do not have one so I can not
say for sure
Looking at the specs and some pictures of disassembled Zauri, I am under
the impression that the SL-C1000 and SL-C3x00 are identical machines,
*except* for the fact that the SL-C1000 lacks some circuitry (buffer and
power?) for an internal "pcmcia" slot (actually a compact flash slot)
holding the internal microdrive.
From everything I can find on the difference it seems what you have listed
I have run my SL-C3100 from the CF flash card exclusively so that is
should work fine.
Is it a reasonable to assume that NetBSD will also boot on a SL-C1000
with a suitably prepared flash card/microdrive in the external CF slot?
(That would then be wd0 at pcmcia1) (would be a big selling point for
me; SL-C1000 is half price and has no moving parts).
Would it be (physically) possible (if SD/MMC were supported) to boot
NetBSD from SD/MMC? (i.e. does the boot loader support that?)
Is the MMC/SD slot on the zaurus actually connected to the MMC/SD
interface of the PXA270? (would be sensible, but you never know)
The zaurus can work both as a USB client and host. The OpenBSD USB stuff
was copied from NetBSD, so could getting USB (host functionality)
working on the zaurus be as easy as adding ohci* at pxaip* to a kernel
Not sure, I only use usb for devices on my zaurus.
What does a zaurus normally do as a USB client? I guess acting as a
memory stick would be quite difficult to reconcile with running a NetBSD
kernel at the same time. Looking at the PXA270 datasheet (
), it looks a complete and very generic USB client interface. This means
that it could be used for /anything/, including emulating a (supported)
usb-ethernet adaptor or a usb-rs232c convertor. The later is probably
easier, but I fancy ethernet would be more usefull. Are there any plans
or is there any prior art WRT using a USB /client/ port under NetBSD?
I use my usb port with a powered hub for wifi, bluetooth, gps so
essientially it's a regular usb port although non-powered.
Main Index |
Thread Index |