On 31 Dec, Ben wrote:

> I plugged it in, powered on the vax (MV3300) and did a "show devices".
> That did not show the card at all. "show qbus" showed a
> TK50/TK70/KQSAetc controller.
I think you will have to go in to the setup of the controller and
configure it. At the Dilog SQ706A there is a 10 pin connector with a
serial interface on it. You con speak to the controler if you plug the
console cable from the CPU board in to this connector and power up the
machine. 
-- 



tschuess,
          Jochen

Homepage: http://www.unixag-kl.fh-kl.de/~jkunz