> Hi,
> 
> I added my 655MB RZ56 disks to the system last night and tried to boot,
> everything looks ok but, the disks need "START_UNIT" command to get
> found, or I belive so, because if I enter "SHOW DEV" they spin up and I
> get correct SCSI information but when I run the kernel I get
> 
> ncr1: no REQ for next phase, abort
> ncr1: no REQ while aborting, reset
> ncr1: reset SCSI bus for TID=2 LUN=0
> ncr1: no REQ for next phase, abort
> ncr1: no REQ while aborting, reset
> ncr1: reset SCSI bus for TID=2 LUN=0
> 
> the two new disks are ID=2 and ID=3
> 
> Any other Ideas ??
> 
A quick try shows that the SCSI probe spins up the disk I have in
a /m38 here; the disk is a RZ23. Then everything works OK.

-- Ragge