kshuff@fast.net wrote:
> 
>  This might be a dumb question, but how do you exit from edlabel? Im
> trying to install a NetBSD Sep 96 release on a MicroVAX II, but every
> time I come to edlabel , I enter the drive geometry and partition
> layout, and enter "q" to quit, then it asks me for another disk to
> label.

  You have to use "w" to write out the label information.  If you do this it
should bring you back to the normal edlabel prompt.

> If I halt the processor, reboot off the installation tape, and
> enter edlabel again and do a "s" for show, nothing was written. How do
> I get out of edlabel and have the information saved?  >

  You're right about how to get out of it--you just missed a step.
  Good luck with it!

-- 
David Evans              (NeXTMail OK)              dfevans@bbcr.uwaterloo.ca
Computer/Synth Junkie                      http://bbcr.uwaterloo.ca/~dfevans/
University of Waterloo         "Default is the value selected by the composer
Ontario, Canada           overridden by your command." - Roland TR-707 Manual