I installed the snapshot over a 1.3.3 installation that
was running on a 3/460.

It seems to run just fine and even detected the 753 SMD
controller and the 1.3Gb E-SMD disk.

I didn't see a configuration message during boot for the
CG3 video board.

It gets an error message complaining that an option for
port map is wrong. The rc.conf file has a -l option and
portmap will only take a -d option.

Systat doesn't work.

Did I skip something in the installation?

Michael Thompson
E-Mail: M_Thompson@IDS.net