Re: Ultra10 problems with -current

[Martin Husemann <martin%duskware.de@localhost>]

FWIW: with serial console and -current my U5 says:

machfb0 at pci1 dev 2 function 0: vendor 0x1002 product 0x4754 (rev. 0x9a)
machfb0: 16 MB aperture at 0xe1000000, 4 KB registers at 0x00000000
machfb0: 2048 KB SGRAM 62.999 MHz, maximum RAMDAC clock 170 MHz
mach64_get_mode: 1152 5304 5432 1528 900 902 938 937
machfb0: initial resolution 1152x864 at 8 bpp
machfb0: attached to /dev/fb0
machfb0: initializing the DSP
wsdisplay1 at machfb0
cmdide0 at pci1 dev 3 function 0
...

and boots just fine.

Maybe it needs a display with edid attached to cause problems? But your
descriptions sounds like you are using the machfb as console?

Martin