Subject: Re: NetBSD 3.0 on E420R - esiop cmd time out locks system
To: None <doomwarriorx@gmail.com>
From: Havard Eidnes <he@uninett.no>
List: port-sparc64
Date: 01/04/2006 02:25:43
...
> i also try NetBSD 2.1 and it crashs with the same timeout command.
> 1.6.2 also crash, but without any information. The system freeze after:
> "scsibus0: waiting 2 seconds for devices to settle..."

For what it's worth, I have an Ultra E420R in service, and it
works fine.  My dmesg output follows below.

Regards,

- Havard

------------------------------

console is /pci@1f,4000/ebus@1/se@14,400000:a
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 2.0.2_STABLE (GENERIC) #4: Fri Oct 28 23:59:46 CEST 2005
        he@betelgeuse.urc.uninett.no:/usr/obj/sys/arch/sparc64/compile/GENERIC
total memory = 4096 MB
avail memory = 3998 MB
bootpath: /pci@1f,4000/scsi@3,0/disk@1,0
mainbus0 (root): SUNW,Ultra-80: hostid 80c612b5
cpu0 at mainbus0: SUNW,UltraSPARC-II @ 450.069 MHz, version 0 FPU
cpu0: 32K instruction (32 b/l), 16K data (32 b/l), 4096K external (64 b/l)
cpu at mainbus0 not configured
cpu at mainbus0 not configured
cpu at mainbus0 not configured
psycho0 at mainbus0 addr 0xfffb4000
SUNW,psycho: impl 0, version 4: ign 7c0 bus range 0 to 0; PCI bus 0
DVMA map: fe000000 to ffffe000
IOTSB: 6748000 to 6750000
pci0 at psycho0
pci0: i/o space, memory space enabled
ebus0 at pci0 dev 1 function 0
ebus0: Sun Microsystems, Inc. PCIO Ebus2, revision 0x01
auxio0 at ebus0 addr 726000-726003, 728000-728003, 72a000-72a003, 72c000-72c003, 72f000-72f003
power at ebus0 addr 724000-724003 ipl 37 not configured
SUNW,pll at ebus0 addr 504000-504002 not configured
sc at ebus0 addr 500000-500007 not configured
sab0 at ebus0 addr 400000-40007f ipl 43: rev 3.2
sabtty0 at sab0 port 0: console i/o
sabtty1 at sab0 port 1
com0 at ebus0 addr 3083f8-3083ff ipl 41: ns16550a, working fifo
kbd0 at com0
com1 at ebus0 addr 3062f8-3062ff ipl 42: ns16550a, working fifo
ms0 at com1
lpt0 at ebus0 addr 3043bc-3043cb, 300398-300399, 700000-70000f ipl 34
fdthree at ebus0 addr 3023f0-3023f7, 706000-70600f, 720000-720003 ipl 39 not configured
clock0 at ebus0 addr 0-1fff: mk48t59
flashprom at ebus0 addr 0-fffff not configured
hme0 at pci0 dev 1 function 1: Sun Happy Meal Ethernet, rev. 1
hme0: interrupting at ivec 3021
hme0: Ethernet address 08:00:20:c6:12:b5
ukphy0 at hme0 phy 1: Generic IEEE 802.3u media interface
ukphy0: OUI 0x0006b8, model 0x000c, rev. 1
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
esiop0 at pci0 dev 3 function 0: Symbios Logic 53c875 (ultra-wide scsi)
esiop0: using on-board RAM
esiop0: interrupting at ivec 20
scsibus0 at esiop0: 16 targets, 8 luns per target
esiop1 at pci0 dev 3 function 1: Symbios Logic 53c875 (ultra-wide scsi)
esiop1: using on-board RAM
esiop1: interrupting at ivec 26
scsibus1 at esiop1: 16 targets, 8 luns per target
psycho1 at mainbus0 addr 0xfffc6000
SUNW,psycho: impl 0, version 4: ign 7c0 bus range 128 to 128; PCI bus 128
pci1 at psycho1
pci1: i/o space, memory space enabled
satalink0 at pci1 dev 1 function 0
satalink0: Silicon Image SATALink 3112 (rev. 0x02)
satalink0: SATALink BA5 register space enabled
satalink0: bus-master DMA support present
satalink0: primary channel wired to native-PCI mode
satalink0: using ivec 0 for native-PCI interrupt
atabus0 at satalink0 channel 0
satalink0: secondary channel wired to native-PCI mode
atabus1 at satalink0 channel 1
timer0 at mainbus0 addr 0xfff9fc00 irq vectors 7ec and 7ed
pcons at mainbus0 not configured
Kernelized RAIDframe activated
scsibus0: waiting 2 seconds for devices to settle...
scsibus1: waiting 2 seconds for devices to settle...
satalink0: port 0: device present, speed: 1.5Gb/s
wd0 at atabus0 drive 0: <WDC WD4000YR-01PLB0>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 372 GB, 775221 cyl, 16 head, 63 sec, 512 bytes/sect x 781422768 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(satalink0:0:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA data transfers)
sd0 at scsibus0 target 0 lun 0: <SEAGATE, ST318203LSUN18G, 034A> disk fixed
sd0: 17274 MB, 7508 cyl, 19 head, 248 sec, 512 bytes/sect x 35378533 sectors
sd0: sync (50.00ns offset 15), 16-bit (40.000MB/s) transfers, tagged queueing
sd1 at scsibus0 target 1 lun 0: <SEAGATE, ST318203LSUN18G, 034A> disk fixed
sd1: 17274 MB, 7508 cyl, 19 head, 248 sec, 512 bytes/sect x 35378533 sectors
sd1: sync (50.00ns offset 15), 16-bit (40.000MB/s) transfers, tagged queueing
cd0 at scsibus0 target 6 lun 0: <TOSHIBA, XM6201TASUN32XCD, 1103> cdrom removable
cd0: sync (100.00ns offset 16), 8-bit (10.000MB/s) transfers
root on sd1a dumps on sd1b
root file system type: ffs