Nevermind, i answered my own question. It appears somewhere in the lifetime
of this poor IPX it was robbed of it's FPU through replacement of the CPU.
Oh well, ill just order another IPX.

Thanks again,
Jonathan
-----Original Message-----
From: port-sparc-owner@netbsd.org [mailto:port-sparc-owner@netbsd.org]On
Behalf Of Jonathan Crawford
Sent: Tuesday, January 22, 2002 7:45 PM
To: port-sparc@netbsd.org
Subject: NetBSD 1.5.2 on IPX boot problems...


Hi everyone,

Im trying to install NetBSD 1.5.2 on my Sparc IPX via netboot. Everything
goes fine, up until right after dma0 is loaded, then i get the error...
---

dma0 at sbus0 slot 0 offset 0x400000data fault: pc=0xf01f3d48 addr=0x0
ser=8080<WRITE,INVAL>
panic: kernel fault
halted

Program terminated

---
I also tried to install OpenBSD on it, and it loaded the kernel fine, but
when it got down to install it started getting problems with floating point
exceptions. This almost makes me think it is a problem with the hardware,
except that it runs SunOS 4.1.3_U1 perfectly without a flaw.

Any ideas?

Thanks,
Jonathan

Boot device: /sbus/le@0,c00000   File and args:
13200
>> NetBSD/sparc Secondary Boot, Revision 1.9
>> (toor@proxima, Tue Aug 21 23:18:13 CST 2001)
Booting netbsd
Using BOOTPARAMS protocol: ip address: 10.10.10.8, hostname: sunbox
root addr=10.10.10.7 path=/exports/sunbox/install/netbsd
2407018+115748+235192 [68+154160+112699]=0x2f29c0
OBP version 2, revision 2.3 (plugin rev 2)
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.5.2 (GENERIC) #0: Wed Aug 22 04:33:09 CST 2001
    toor@proxima:/usr/src/sys/arch/sparc/compile/GENERIC
total memory = 16260 KB
avail memory = 12556 KB
using 128 buffers containing 512 KB of memory
bootpath: /sbus0/le@0,c00000
mainbus0 (root): SUNW,Sun 4/50
cpu0 at mainbus0: cache chip bug; trap page uncached: CY7C601 @ 40 MHz, no
FPU
cpu0: 64K byte write-through, 32 bytes/line, hw flush: cache enabled
memreg0 at mainbus0 ioaddr 0xf4000000
clock0 at mainbus0 ioaddr 0xf2000000: mk48t02 (eeprom)
timer0 at mainbus0 ioaddr 0xf3000000 ipl 10 delay constant 17
auxreg0 at mainbus0 ioaddr 0xf7400003
zs0 at mainbus0 ioaddr 0xf1000000 ipl 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at mainbus0 ioaddr 0xf0000000 ipl 12 softpri 6
kbd0 at zs1 channel 0
ms0 at zs1 channel 1
audioamd0 at mainbus0 ioaddr 0xf7201000 ipl 13 softpri 4
audio0 at audioamd0: full duplex
sbus0 at mainbus0 ioaddr 0xf8000000: clock = 20 MHz
dma0 at sbus0 slot 0 offset 0x400000data fault: pc=0xf01f9720 addr=0x0
ser=8080<WRITE,INVAL>
panic: kernel fault
halted