Thank you so much. With that command, I found out about
target and unit.

Hoang

--- Jon Lindgren <jlindgren@espus.com> wrote:
> On Wed, 3 May 2000, Hoang Tran wrote:
> 
> > Hi,
> > 
> > I just installed NetBSD 1.4.2 into a SS2 w/o any problems
> > but unable to boot it off the hardrive with the following
> > message:
> > 
> > ok setenv boot-file netbsdb
> > boot-file =            netbsd
> > ok setenv boot-device /sbus/esp/sd@0,0
> > boot-device =         /sbus/esp/sd@0,0
> > ok boot
> > Boot device: /sbus/esp/sd@0,0   File and args netbsd
> > SCSI device 0,0 is not responding
> > Can't open boot device
> > 
> > Any suggestions is greatly appreciated.
> 
> Does a "probe-scsi" show anything at ID 0?
> 
> -Jon
>  --------------------------------------------------------------------
>  "There is no fourth tower of Inverness!!!" -Meatball Fulton
> 
> 

__________________________________________________
Do You Yahoo!?
Send instant messages & get email alerts with Yahoo! Messenger.
http://im.yahoo.com/