Hangs hard after the last line.

christos

SPARCstation 10  (1 X 390Z50), No Keyboard
ROM Rev. 2.12, 160 MB memory installed, Serial #3316210.
Ethernet address 8:0:20:1e:2b:f3, Host ID: 723299f2.


Rebooting with command:                                               
Boot device: /iommu/sbus/espdma@f,400000/esp@f,800000/sd@3,0   File and args: 
>> NetBSD/sparc Secondary Boot, Revision 1.9
>> (christos@oxygene.gw.com, Sat Jun 26 13:02:26 EDT 1999)
Booting netbsd
1961116+108404+196844 [68+130704+92924]=0x270094
OBP version 3, revision 2.12 (plugin rev 2)
console is ttya
Copyright (c) 1996, 1997, 1998, 1999
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.4I (GENERIC) #10: Wed Jul 28 10:59:53 EDT 1999
    root@oxygene.gw.com:/net/hrothgar/src-1/NetBSD/cvsroot/src/sys/arch/sparc/compile/GENERIC
total memory = 159 MB
avail memory = 144 MB
using 2064 buffers containing 8256 KB of memory
bootpath: /iommu@f,e0000000/sbus@f,e0001000/espdma@f,400000/esp@f,800000/sd@3,0
mainbus0 (root): SUNW,SPARCstation-10
cpu0 at mainbus0: TMS390Z50 v1 @ 40 MHz, on-chip FPU
cpu0: physical 20K instruction (64 b/l), 16K data (32 b/l): cache enabled
obio0 at mainbus0
clock0 at obio0 slot 0 offset 0x200000: mk48t08 (eeprom)
timer0 at obio0 slot 0 offset 0x300000 delay constant 18
zs0 at obio0 slot 0 offset 0x100000 level 12 softpri 6
zstty0 at zs0 channel 0 (console)
zstty1 at zs0 channel 1
zs1 at obio0 slot 0 offset 0x0 level 12 softpri 6
kbd0 at zs1 channel 0
ms0 at zs1 channel 1
fdc0 at obio0 slot 0 offset 0x700000 level 11 softpri 4: chip 82077
auxreg0 at obio0 slot 0 offset 0x800000
power0 at obio0 slot 0 offset 0xa01000 level 2
iommu0 at mainbus0 ioaddr 0xe0000000: version 0x3/0x0, page-size 4096, range 64MB
sbus0 at iommu0: clock = 20 MHz
dma0 at sbus0 slot 15 offset 0x400000: rev 2
esp0 at dma0 slot 15 offset 0x800000 level 4: ESP200, 40MHz, SCSI ID 7
scsibus0 at esp0: 8 targets, 8 luns per target
probe(esp0:3:0): max sync rate 10.00Mb/s
sd0 at scsibus0 targ 3 lun 0: <SEAGATE, ST31200N SUN1.05, 8722> SCSI2 0/direct fixed
sd0: 1006 MB, 2700 cyl, 9 head, 84 sec, 512 bytes/sect x 2061108 sectors
ledma0 at sbus0 slot 15 offset 0x400010: rev 2
le0 at ledma0 slot 15 offset 0xc00000 level 6: address 08:00:20:1e:2b:f3
le0: 8 receive buffers, 2 transmit buffers
SUNW,bpp at sbus0 slot 15 offset 0x4800000 level 2 (ipl 3) not configured
SUNW,DBRIe at sbus0 slot 15 offset 0x8010000 level 9 not configured
cgsix0 at sbus0 slot 2 offset 0x0 level 9: SUNW,501-1672, 1152 x 900, rev 8
eccmemctl0 at mainbus0: version 0x0/0x1
root on sd0a dumps on sd0b
root file system type: ffs