> On 10-Dec-98 Jack Culpepper spoke unto us all:
> #  Hi,
> #  
> #  I managed to put a label on sd0, my smaller drive.  I then put a filesystem
> #  on it, no problem, I am using it fine now.  But I am still getting "device
> #  not configured" when I try to use the other one.  The kernel seems to see it
> #  just fine, and it's in the disktab.  Any ideas?
> 
> Make sure you have entries for it in /dev.  You will also get "device not
> configured" if you do something like try to dd to /dev/sd1a if you haven't
> labeled that disk yet.

I can't label the disk without getting the 'device not configured'.  I just
rebuilt my device tree, so that can't be the problem.  Again, here is what
the kernel spits out, so I think the device _is_ being configured:

sd0 at scsibus0 targ 0 lun 0: <CONNER, CP30540 545MB3.5, B0BC> SCSI2 0/direct fixed
sd0: 520MB, 2242 cyl, 6 head, 79 sec, 512 bytes/sect x 1065912 sectors
probe(esp0:4:0): max sync rate 10.00Mb/s
sd1 at scsibus0 targ 4 lun 0: <SEAGATE, ST15230N, 0638> SCSI2 0/direct fixed
sd1: 4095MB, 3992 cyl, 19 head, 110 sec, 512 bytes/sect x 8386733 sectors

sd0 works fine.

Jack