On Fri, 23 Feb 1996 14:37:58 -0500 (EST) 
 Mike Frisch <mfrisch@saturn.tlug.org> wrote:

 > 	I just installed a VME Ethernet card into my 4/110 running 
 > NetBSD/sparc 1.1 and am having some problems.  Upon boot, the kernel 
 > displays the following message:
 > 
 > ie1 at vmes0 addr 0xffe88000 vec 0x75: RAM CONFIG FAILED!
 > 
 > 	Is this indictive of the card being bad or is it just 
 > configured?  For that matter, is this supported by NetBSD/sparc?

I'm not sure that it's possible to use the DVMA-savvy boards on the 
4/100.  I think you're pretty much limited to serial boards, and the 
like.  The 4/100 was pretty weak in the VME arena ... I think the one 
slot was kind of token...

Then again, I could be totally wrong ... Chuck would probably know :-)

--------------------------------------------------------------------------
Jason R. Thorpe                                       thorpej@nas.nasa.gov
NASA Ames Research Center                               Home: 408.866.1912
NAS: M/S 258-6                                          Work: 415.604.0935
Moffett Field, CA 94035                                Pager: 415.428.6939