Re: Set 100Mb card not working on 5.0

[Izumi Tsutsui <tsutsui%ceres.dti.ne.jp@localhost>]

I wrote:

> > tsutsui@ appears to have most recently modified tl(4). Perhaps he can  
> > confirm that it's not broken on other ports.
> 
> 5.99.11 macppc GENERIC kernel says:
> 
> tl0 at pci0 dev 13 function 0
> tl0: Compaq Netelligent 10/100 TX
> tl0: Ethernet address 00:80:5f:8b:55:cc
> tl0: interrupting at irq 23
> nsphy0 at tl0 phy 1: DP83840 10/100 media interface, rev. 1
> nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> tlphy0 at tl0 phy 31: ThunderLAN 10BASE-T media interface, rev. 5
> tlphy0: no media present

The same card also seems to work on IP32 with 5.0 GENERIC32_IP3x kernel:

---
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 5.0 (GENERIC32_IP3x) #0: Mon Apr 27 06:14:57 UTC 2009
        
builds%b1.netbsd.org@localhost:/home/builds/ab/netbsd-5-0-RELEASE/sgimips/200904260229Z-obj/home/builds/ab/netbsd-5-0-RELEASE/src/sys/arch/sgimips/compile/GENERIC32_IP3x
total memory = 256 MB
(6848 KB reserved for ARCS)
avail memory = 237 MB
mainbus0 (root): SGI-IP32 [SGI, 9], 1 processor
cpu0 at mainbus0: MIPS R5000 CPU (0x2321) Rev. 2.1 with built-in FPU Rev. 1.0
cpu0: 32KB/32B 2-way set-associative L1 Instruction cache, 48 TLB entries
cpu0: 32KB/32B 2-way set-associative write-back L1 Data cache
cpu0: 512KB/32B direct-mapped write-through L2 Unified cache
crime0 at mainbus0 addr 0x14000000: rev 1.1 (CRIME_ID: 161)
crmfb0 at mainbus0 addr 0x16000000: SGI CRIME Graphics Display Engine
crmfb0: device unusable if not setup by firmware
mace0 at mainbus0 addr 0x1f000000
lpt0 at mace0 offset 0x380000 intr 4 intrmask 0xf0000
com0 at mace0 offset 0x390000 intr 4 intrmask 0x3f00000: ns16550a, working fifo
com0: console
com1 at mace0 offset 0x398000 intr 4 intrmask 0xfc000000: ns16550a, working fifo
macekbc0 at mace0 offset 0x320000 intr 5 intrmask 0x0: PS2 controller
mcclock0 at mace0 offset 0x3a0000 intrmask 0x0
mec0 at mace0 offset 0x280000 intr 3 intrmask 0x0: MAC-110 Ethernet, rev 1
mec0: Ethernet address 08:00:69:0c:95:79
nsphy0 at mec0 phy 8: DP83840 10/100 media interface, rev. 0
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
mavb0 at mace0 offset 0x300000 intr 6 intrmask 0x0: AD1843 rev 1
audio0 at mavb0: full duplex, independent
macepci0 at mace0 offset 0x80000 intr 7 intrmask 0x0: rev 1
pci0 at macepci0 bus 0
ahc0 at pci0 dev 1 function 0: Adaptec aic7880 Ultra SCSI adapter
ahc0: interrupting at crime interrupt 8
ahc0: Using left over BIOS settings
ahc0: Host Adapter has no SEEPROM. Using default SCSI target parameters
ahc0: aic7880: Ultra Wide Channel A, SCSI Id=0, 16/253 SCBs
scsibus0 at ahc0: 16 targets, 8 luns per target
ahc1 at pci0 dev 2 function 0: Adaptec aic7880 Ultra SCSI adapter
ahc1: interrupting at crime interrupt 9
ahc1: Using left over BIOS settings
ahc1: Host Adapter has no SEEPROM. Using default SCSI target parameters
ahc1: aic7880: Ultra Wide Channel A, SCSI Id=0, 16/253 SCBs
scsibus1 at ahc1: 16 targets, 8 luns per target
tl0 at pci0 dev 3 function 0
tl0: Compaq Netelligent 10/100 TX
tl0: Ethernet address 00:80:5f:8b:55:cc
tl0: interrupting at crime interrupt 10
nsphy1 at tl0 phy 1: DP83840 10/100 media interface, rev. 1
nsphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlphy0 at tl0 phy 31: ThunderLAN 10BASE-T media interface, rev. 5
tlphy0: no media present
scsibus0: waiting 2 seconds for devices to settle...
scsibus1: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 1 lun 0: <SGI, IBM DCAS-32160W, S62A> disk fixed
sd0: 2049 MB, 8188 cyl, 3 head, 170 sec, 512 bytes/sect x 4197405 sectors
sd0: sync (50.00ns offset 8), 16-bit (40.000MB/s) transfers, tagged queueing
cd0 at scsibus0 target 4 lun 0: <TOSHIBA, CD-ROM XM-5701TA, 0167> cdrom 
removable
cd0: sync (100.00ns offset 8), 8-bit (10.000MB/s) transfers
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs
---
Izumi Tsutsui