Hello,

I've been trying ever snapshot as soon as they come out,
and this one is the best so far. :)  I went through the entire
installation until the very end.  At that point I attempted
to boot from the local drive but there seems to be a problem.
  This machine is an R5000 Indy that has a processor upgrade
(hinv below) not long before it was taken out of service and
given to me.  ClearCase (like cvs for those who want to pay)
brought out a bug in the older chips, so it was replaced by SGI for
free.
I'm not sure if this is relevant, but the machine is a 180Mhz
R5K a bit faster than the 150 R5K that was tested.
  Could someone take a look at the error message and tell me where
I might have gone wrong?  It seems to be complaining about the
swap...

Thanks,

Robert


>> setenv OSLoadFilename netbsd
>> boot

NetBSD/sgimips 1.5ZA Bootstrap, Revision 1.1
(root@mod81, Wed Mar  6 07:36:24 UTC 2002)

Mem block: type 0 base 0x0 size 0x1000
Mem block: type 1 base 0x1000 size 0x1000
Mem block: type 3 base 0x8002000 size 0x73e000
Mem block: type 6 base 0x8740000 size 0xc0000
Mem block: type 3 base 0x8800000 size 0x800000
Mem block: type 5 base 0x9000000 size 0xc000
Mem block: type 3 base 0x900c000 size 0x6ff4000
Local storage a87ff168
argv[0]: scsi(0)disk(1)rdisk(0)partition(8)/boot.elf
argv[1]: ConsoleIn=serial(0)
argv[2]: ConsoleOut=serial(0)
argv[3]: SystemPartition=scsi(0)disk(1)rdisk(0)partition(8)
argv[4]: OSLoader=boot.elf
argv[5]: OSLoadPartition=scsi(0)disk(1)rdisk(0)partition(0)
argv[6]: OSLoadFilename=netbsd
Boot: scsi(0)disk(1)rdisk(0)partition(0)netbsd
devopen: scsi(0)disk(1)rdisk(0)partition(0) type scsi file netbsd
1501808+140700 [61584+50790]=0x1ac918
Starting at 0x88069000

nsym 0x1 ssym 0x881fa00c esym 0x88215918
Found bootinfo at 0x8900b3f0
zs channel 0 had address 0xbfbd9830
argv[0]: scsi(0)disk(1)rdisk(0)partition(8)/boot.elf
argv[1]: ConsoleIn=serial(0)
argv[2]: ConsoleOut=serial(0)
argv[3]: SystemPartition=scsi(0)disk(1)rdisk(0)partition(8)
argv[4]: OSLoader=boot.elf
argv[5]: OSLoadPartition=scsi(0)disk(1)rdisk(0)partition(0)
argv[6]: OSLoadFilename=netbsd
[ using 112908 bytes of netbsd ELF symbol table ]
IOC rev 1, machine Indy (Guiness), board rev 3
Timer calibration, got 900000 cycles (900000, 900000, 900000)
CPU clock speed = 90.00Mhz
Mem block 1: type 0, base 0x0, size 0x1
Mem block 2: type 1, base 0x1, size 0x1
Mem block 3: type 3, base 0x8002, size 0x73e
Mem block 4: type 6, base 0x8740, size 0xc0
Mem block 5: type 3, base 0x8800, size 0x800
Mem block 6: type 5, base 0x9000, size 0xc
Mem block 7: type 3, base 0x900c, size 0x6ff4
Cluster 2 contains kernel
Loading chunk before kernel: 0x8002 / 0x8069
Loading chunk after kernel: 0x8216 / 0x8740
Loading cluster 4: 0x8800 / 0x9000
Loading cluster 5: 0x9000 / 0x900c
Loading cluster 6: 0x900c / 0x10000
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.5ZA (GENERIC) #3: Mon Mar 11 08:23:44 CST 2002
    root@mod81:/sgimips/obj.release/sys/arch/sgimips/compile/GENERIC
128 MB memory, 115 MB free, 768 KB for ARCS, 6656 KB in 1664 buffers
trap: TLB miss (load or instr. fetch) in kernel mode
status=0x20000002, cause=0x8008, epc=0x88080be4, vaddr=0x0
pid=0 cmd=swapper usp=0x0 ksp=0x8802fe68
Stopped in pid 0 (swapper) at   main+0x444:     lw      v0,0(v1)
db> 



sash: version
Standalone Shell SGI Version 6.5 ARCS   Apr 11, 2000 (32 Bit)
sash: hinv
                   System: IP22
                Processor: 180 Mhz R5000, with FPU
     Primary I-cache size: 32 Kbytes
     Primary D-cache size: 32 Kbytes
     Secondary cache size: 512 Kbytes
              Memory size: 128 Mbytes
                 Graphics: GR3-XZ
                SCSI Disk: scsi(0)disk(1)
                SCSI Disk: scsi(0)disk(2)
                    Audio: Iris Audio Processor: version A2 revision
4.1.0

hinv from irix:
CPU: MIPS R5000 Processor Chip Revision: 2.1
FPU: MIPS R5000 Floating Point Coprocessor Revision: 1.0
1 180 MHZ IP22 Processor
Main memory size: 128 Mbytes
Secondary unified instruction/data cache size: 512 Kbytes on Processor 0
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Integral SCSI controller 0: Version WD33C93B, revision D
  Disk drive: unit 1 on SCSI controller 0
  Disk drive: unit 2 on SCSI controller 0
On-board serial ports: 2
On-board bi-directional parallel port
Graphics board: GR3-XZ
Integral Ethernet: ec0, version 1
Integral ISDN: Basic Rate Interface unit 0, revision 1.0
Iris Audio Processor: version A2 revision 4.1.0
Vino video: unit 0, revision 0