Folks

have just been having a look at getting the 'sq' device on the challenge 's' mezz. board. But I keep getting:

NetBSD 1.5ZA (NEWINDY) #3: Wed Feb  6 14:14:21 GMT 2002
    root@indy:/usr/src/sys/arch/sgimips/compile/NEWINDY
256 MB memory, 234 MB free, 768 KB for ARCS, 13208 KB in 3302 buffers
mainbus0 (root): SGI-IP22 [SGI, 6908debe], 1 processor
cpu0 at mainbus0: MIPS R4400 CPU (0x460) Rev. 6.0 with MIPS R4010 FPC Rev. 0.0
cpu0: 16KB/16B direct-mapped L1 Instruction cache, 48 TLB entries
cpu0: 16KB/16B direct-mapped write-back L1 Data cache
cpu0: 1024KB/128B direct-mapped write-back L2 Unified cache
imc0 at mainbus0 addr 0x1fa00000
imc0: Revision 3
gio0 at imc0
hpc0 at gio0 addr 0x1fb80000: SGI HPC3
zsc0 at hpc0 offset 0x59830
zstty0 at zsc0 channel 1 (console i/o)
zstty1 at zsc0 channel 0
sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
sq0: Ethernet address 08:00:69:08:de:be
wdsc0 at hpc0 offset 0x44000: WD33C93B SCSI, rev=0, target 7
scsibus0 at wdsc0: 8 targets, 8 luns per target
dsclock0 at hpc0 offset 0x60000
hpc1 at gio0 addr 0x1fb00000: SGI HPC3
zsc at hpc1 offset 0x59830 not configured
sq1 at hpc1 offset 0x54000panic: cannot share CPU interrupts
Stopped in pid 0 (swapper) at   0x88160244:     jr      ra
                bdslot: nop

is this because i'm not accessing the 'hpc' on the mez. but acctually accessing the mainboard 'hpc' via a different address. Should I be infact trying to access 'hpc1' via a different 'gio'? Or am I talking gibberish, in which case could someone please point out my error, and then i shall go on my way.

Cheers

Steve