Re: Pegasos port status

[Matt Thomas <matt%3am-software.com@localhost>]

Jonas Sundström wrote:
> Matt Thomas <matt%3am-software.com@localhost> wrote:
>  ...
>> I bought one intending to get it supported.  Except
>> I could never get any technical information from 
>> Genesi about it so I went on to other things.
>>
>> My questions where mostly on how the Pegasos 
>> boards used the MPP pins on the Discovery/
>> DiscoveryII system controller and what was attached
>> to each device bus and where.  There are 32 MPP 
>> pins used for inputs, outputs, interrupts, NMI, watchdog,
>> timers, and other assorted purposes.  Knowing how 
>> these pins are used is critical in writing the board 
>> dependent support.
> 
> FWIW, there's a PDF on the Pegasos, at Power.org.
> I'm not an engineer, but it looks like it tells how all the
> chips are connected.
> 
> http://www.power.org/members/developers/downloads/genesi_pegasosppc
> (You need to be a member to get there.)

That PDF only covers the motherboard but not the CPU daughterboard.
So it's only somewhat useful.

-- 
Matt Thomas                     email: matt%3am-software.com@localhost
3am Software Foundry              www: http://3am-software.com/bio/matt/
Cupertino, CA              disclaimer: I avow all knowledge of this message.