Peter Seebach wrote:
> In message <42D0EB10.7040501@ntlworld.com>, Richard Danter writes:
> 
>>Hi All,
>>
>>I would like to port NetBSD to a new board but it seems there are 
>>several different PowerPC ports and I am not sure which to start with.
>>
>>The board contains a MPC7400 with a 107 memory controller using address 
>>map B (CHRP). The bootloader is U-Boot, which I have almost finished 
>>porting (it boots from Flash, just need to get the network working).
>>
>>Any suggestions which of the PPC ports I should start with? Any other 
>>advice?
> 
> 
> Which board is it?  Got pointers to spec sheets?  It is theoretically possible
> that someone else has already looked at it.

It is a custom board. All it has is the CPU, 107, 64MB RAM, 4MB Flash 
and a serial interface. There are a couple of PCI slots one of which has 
an Intel EEPro 10/100 network card.

Rich