Re: Powerpc signal handler with floating point registers

To: chris zhang <sileizhang%yahoo.com@localhost>
Subject: Re: Powerpc signal handler with floating point registers
From: Matt Thomas <matt%3am-software.com@localhost>
Date: Fri, 25 Feb 2005 11:14:02 -0800

At 10:32 AM 2/25/2005, chris zhang wrote:

Hi,
I'm using NetBSD 2.0-RC4 on a powerpc 603 processor
which has the hardware floating point component
enabled. I ran into a situation where it seems the
powerpc floating point registers are not
saved/restored properly by the signal handler.


I've checked in a fix which should fix this.


--
Matt Thomas                     email: matt%3am-software.com@localhost
3am Software Foundry              www: http://3am-software.com/bio/matt/
Cupertino, CA              disclaimer: I avow all knowledge of this message.

References:
- Powerpc signal handler with floating point registers
  - From: chris zhang

Prev by Date: Powerpc signal handler with floating point registers
Next by Date: Re: Powerpc signal handler with floating point registers
Previous by Thread: Powerpc signal handler with floating point registers
Next by Thread: Re: Powerpc signal handler with floating point registers
Indexes:

Home | Main Index | Thread Index | Old Index