At 10:32 AM 2/25/2005, chris zhang wrote:
>Hi,
>I'm using NetBSD 2.0-RC4 on a powerpc 603 processor
>which has the hardware floating point component
>enabled. I ran into a situation where it seems the
>powerpc floating point registers are not
>saved/restored properly by the signal handler.

I've checked in a fix which should fix this.


-- 
Matt Thomas                     email: matt@3am-software.com
3am Software Foundry              www: http://3am-software.com/bio/matt/
Cupertino, CA              disclaimer: I avow all knowledge of this message.