Subject: Re: A couple of suggestions
To: Derek God3 <firstname.lastname@example.org>
From: Matt Thomas <email@example.com>
Date: 01/06/2004 11:11:28
At 11:06 AM 1/6/2004, Derek God3 wrote:
>because my port/board is a completley differnet
>machine than say a "walnut". It boots differently, installs differently
>has support for different MBR, partitions and bootlabels, a different
>set of "standard" devices, in fact, the only thing in common is the cpu :-)
>While it is easy enought to replace the "walnut" definitions for evbppc
>it is not so easy to support more that one of these at once from the
>same source base. Subdirectories based on boardtype would make this easy
>(which is what I did) - but I'm sure there would other ways too.
Different MBR? It either uses the standard MBR or it doesn't.
What type of disklabel does it use? What type of bootlabels?
Matt Thomas email: firstname.lastname@example.org
3am Software Foundry www: http://3am-software.com/bio/matt/
Cupertino, CA disclaimer: I avow all knowledge of this message.