To restore the VXT to the factory settings, which will make it possible to
re-enable Motif and reset IP and so forth, follow the instructions below.
They are an excerpt of the manual for the VXT terminal.

<snip>
A.3 Restoring the Terminal to Factory-Default Settings
  You can reset the VXT 2000 windowing terminal's non-
  volatile RAM (NVRAM) to the factory-default settings by
  entering a console command.
  1. Place the terminal in console mode by pressing Ctrl+Alt+keypad .
  or pressing the halt button on the rear of the terminal.
  2. At the >>> console prompt, enter the following command:
     >>> T/UTIL 1
  When you boot the terminal successfully it saves a record
  of the successful booting method used. When you reboot the
  terminal, it tries using this saved method first. You can clear
  this saved state while booting the terminal:
  >>> B/10000
</snip>

The complete manual can be viewed at http://www.hogrelius.nu/~ahs/vxt/
and the software packages that are available for VMS can be found at
ftp://ftp.hogrelius.nu/private/ahs/vxt

--
cheers,

/Anders

Pain is a thing of the mind.  The mind can be controlled.
		-- Spock, "Operation -- Annihilate!" stardate 3287.2

*************************************************************************
* Anders Hogrelius       Phone : +46 (0)70 6770210
* Tessingatan 12         E-mail: anders@hogrelius.nu
* SE-72216 Vasteras      Web:    http://www.hogrelius.nu/~ahs/
* SWEDEN