Now it booted!

The outputs are shown below:
......
NetBSD 1.3.2 (GENERIC) #0: Tue May 12 16:23.11 PDT 1998
	jonathan@......
real mem=33554432
avail mem=27574272
using 819 buffers containing 33554432 bytes of mem
mainbus0 (root)
cpu0 at mainbus0: MIPS R4400 CPU Rev.4.0 with MIPS R4010 FPC Rev. 0.0
    L1 cache: 16kb Instruction, 16kb Date, L2 cache: 1024 mixed.
tc0 at mainbus0: 25MHz clock
asic0 at tc0 slot 3 offset 0x0
le0 at asic0 offset 0xc0000 priority 4: address 08:00:2b:39:c5:2f
le0: 32 receive buffers, 8 transmit buffers
   scc0 at asic0 offset 0x100000 priority 6
   scc1 at asic0 offset 0x180000 priority 5

It stopped here. Why?

The drives connected are:
-------------------------------------------------
DEV  PID            VID       REV        SCSI DEV
=================================================
rz0  RZ58  (c)DEC   DEC       2000       DIR
rz1  RX23  (c)DEC   DEC       0054       DIR
tz5                                      SEQ

I find that the switch position on the back of the TZK30-tape
driver is(from left to right):
      (2) up up down (1) down down down
While the switch position on the back of the RX23-diskette
driver is:
      (2) down down down (1) down down down

Now, can anyone tell me if there's anything wrong with the
SCSI ID setting of the drivers? If not this problem, then what
should I do next?

Thank you very much!
-----------------------------------------------------------
| Sonnie Hook |    sonnie@263.net      sonnie@126.com     |
-----------------------------------------------------------
|     the State Key Laboratory of Fire Science(SKLFS)     |
| the University of Science and Technology of China(USTC) |
-----------------------------------------------------------

__________________________________________________
欢迎使用首都在线免费电子邮箱http://freemail.263.net