Subject: What am I doing wrong?
To: None <>
From: Ken Wellsch <>
List: port-pmax
Date: 08/12/1998 23:02:26
I am trying to get a DECstation 5000/125 going and get this far:

>>boot 3/tftp
Using PROM serial output until serial drivers initialized
Copyright (c) 1996, 1997, 1998
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.3.2 (INSTALL) #0: Tue May 12 20:36:20 PDT 1998
real mem = 33554432
avail mem = 27987968
using 819 buffers containing 3354624 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: MIPS R3000 CPU Rev. 3.0 with MIPS R3010 FPC Rev. 4.0
        L1 cache: 64kb Instruction, 64kb Data.
tc0 at mainbus0: 12.5 MHz clock
asic0 at tc0 slot 3 offset 0x0
le0 at asic0 offset 0xc0000 priority 4: address 08:00:2b:2f:d5:51
le0: 32 receive buffers, 8 transmit buffers
scc0 at asic0 offset 0x100000 priority 6
scc1 at asic0 offset 0x180000 priority u (In sccattach: cn_dev = 0x1102) (Unit = 1): console
clock0 at asic0 offset 0x200000 priority 0: mc146818 or compatible
asc0 at asic0 offset 0x300000 priority 3: target 7
device PMAG-DA  at tc0 slot 2 offset 0x0 not configured
Beginning old-style SCSI device autoconfiguration

then it hangs.  I have no disk installed (well, I had an old 300Mb drive
but it did the same - it is not a DEC disk either - so I unplugged the
power to see whether it might be hanging things).

What am I doing wrong?

-- Ken Wellsch