Subject: Re: RZ25-E SCSI Id jumpers?
To: None <port-pmax@NetBSD.ORG>
From: Toru Nishimura <>
List: port-pmax
Date: 09/17/1997 09:25:58
> Does anyone know how to configure the SCSI ID jumpers on an RZ25
> drive?  (The label says RZ25-E, if that makes a difference.)

RZ25 has two sets of pins for SCSI ID.  When the drive is holded right
side up (power and SCSI connecter behind), one (smaller) set is at
right front side; 5 pins, and another 3 pins set (larger) is at left

The left most 3 pins at front work as SCSI ID.  Read pin #1, #2, #3 (from
left) as digit 2^2, 2^1, 2^0 respectively.  #4 is always ON.

If you use left side pins, they represent 2^0, 2^1, 2^0 front to back.  In
this case, you clear all 3 pins on front side.

Tohru Nishimura
Nara Institute of Science and Technology