Jonathan helped me get to this point, but now I am stuck.

Here is my configuration:

A 5000/120 - 3MIN box. It has 2 internal rz25s (rz0, rz1) an internal
CD drive (rz4) and then an expansion box with a Seagate 1GB disk (rz2).

When I boot it up in this configuration it sees rz0 and rz1 but then
in asc_intr it goes into the default, dumps out the asc log, and
reboots.

If I turn off the expansion box, disconnect it from the machine and then
put a scsi terminator on the machine netbsd sees rz0, prints out that
rz1 is not ready, and then properly sees rz1. It then gives me the
single user # sign.

Any suggestions why the above scenarios are happening??

yoseff