Hi,

I've installed NetBSD/macppc 3.1 on a Performa 6360, accessing via
serial console throught minicom-2.1 from pkgsrc-2006Q4 on a
NetBSD/amd64 machine. I setup dhclient to get an IP address from a DSL
modem/router. No problem at all.

But every time I reboot NetBSD/amd64, NetBSD/macppc gets into db>,
where I can reboot from it. If I enter OpenBSD/amd64 installed on the
same machine, same problem occurs.

I thought it could be something related to DHCP, but I'm not sure. Are
there any information from db> I should send? The output got from
serial port of the booting process is below. Should I send a PR?

Thank you.

--
Open Firmware, 2.0
To continue booting the MacOS type:
BYE<return>
To continue booting from the default boot device type:
BOOT<return>
 ok
0 > boot 
OF_open bootpath=ata/ATA-Disk@0
read stage 2 blocks: 0123456. done!
starting stage 2...

>> NetBSD/macppc OpenFirmware Boot, Revision 1.10
>> (builds@b1.netbsd.org, Tue Oct 31 04:33:41 UTC 2006)
Cannot use bootpath
Using boot-device instead
no active package5125316+218356 [264880+244429]=0x5952b4
 start=0x100000
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 3.1 (GENERIC) #0: Tue Oct 31 05:09:13 UTC 2006
        builds@b1.netbsd.org:/home/builds/ab/netbsd-3-1-RELEASE/macppc/200610302
053Z-obj/home/builds/ab/netbsd-3-1-RELEASE/src/sys/arch/macppc/compile/GENERIC
total memory = 16384 KB
avail memory = 8860 KB
no active packagemainbus0 (root)
cpu0 at mainbus0: 603ev (Revision 2.1), ID 0 (primary)
cpu0: HID0 90c001<DOZE,DPM,ICE,DCE,NOPTI>
cpu0: ohare L2 cache enabled
bandit0 at mainbus0
pci0 at bandit0 bus 0
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 11 function 0
pchb0: Apple Computer Bandit Host-PCI Bridge (rev. 0x03)
rtk0 at pci0 dev 13 function 0: Realtek 8139 10/100BaseTX
rtk0: interrupting at irq 23
rtk0: Ethernet address 00:e0:7d:cf:01:e7
ukphy0 at rtk0 phy 7: Generic IEEE 802.3u media interface
ukphy0: OUI 0x000000, model 0x0000, rev. 0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
obio0 at pci0 dev 16 function 0: addr 0xf3000000
mesh0 at obio0 offset 0x10000 irq 12: 50MHz, SCSI ID 7
scsibus0 at mesh0: 8 targets, 8 luns per target
zsc0 at obio0 offset 0x13000: irq 15,16
zstty0 at zsc0 channel 0 (console)
zstty1 at zsc0 channel 1
awacs at obio0 offset 0x14000 not configured
swim3 at obio0 offset 0x15000 not configured
nvram0 at obio0 offset 0x60000
adb0 at obio0 offset 0x16000 irq 18: 1 targets
aed0 at adb0 addr 0: ADB Event device
akbd0 at adb0 addr 2: extended keyboard
wskbd0 at akbd0 mux 1
wdc0 at obio0 offset 0x20000 irq property not found; using 13: DMA
transfer atabus0 at wdc0 channel 0
Kernelized RAIDframe activated
scsibus0: waiting 2 seconds for devices to settle...
cd0 at scsibus0 target 2 lun 0: <MATSHITA, CD-ROM CR-8008, 8.0h> cdrom
removable wd0 at atabus0 drive 0: <QUANTUM FIREBALL_TM1280A>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 1222 MB, 2484 cyl, 16 head, 63 sec, 512 bytes/sect x 2503872
sectors wd0: drive supports PIO mode 4, DMA mode 2
wd0(wdc0:0:0): using PIO mode 4, DMA mode 2 (using DMA)
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
Tue Oct 31 13:12:29 GMT 2006
swapctl: adding /dev/wd0b as swap device at priority 0
Checking for botched superblock upgrades: done.
Starting file system checks:
/dev/rwd0a: file system is clean; not checking
/dev/rwd0d: file system is clean; not checking
/dev/rwd0e: file system is clean; not checking
/dev/rwd0g: file system is clean; not checking
Setting tty flags.
Setting sysctl variables:
Starting network.
Hostname: AMPARO05
IPv6 mode: host
Configuring network interfaces:.
Starting dhclient.
Internet Software Consortium DHCP Client V3.0.1rc11
Copyright 1995-2002 Internet Software Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP

Listening on BPF/rtk0/00:e0:7d:cf:01:e7
Sending on   BPF/rtk0/00:e0:7d:cf:01:e7
Sending on   Socket/fallback
DHCPREQUEST on rtk0 to 255.255.255.255 port 67
DHCPREQUEST on rtk0 to 255.255.255.255 port 67
ip length 314 disagrees with bytes received 318.
accepting packet with data after udp payload.
DHCPACK from 192.168.1.1
bound to 192.168.1.5 -- renewal in 1043609 seconds.
Building databases...
Starting syslogd.
Checking for core dump...
savecore: no core dump
Mounting all filesystems...
Clearing /tmp.
Checking quotas: done.
Starting virecover.
Starting local daemons:.
Updating motd.
Starting sshd.
Starting inetd.
Starting cron.
Tue Oct 31 13:12:58 UTC 2006

NetBSD/macppc (AMPARO05) (tty00)

login: