Hello again,

...just for the archive...
> 
> Am Sat den 12 Aug 2006 um 01:43:35AM -0500 schrieb Jonathan A. Kollasch:
> > > 1. Does this G4 Cube 128GB barrier exist in NetBSD also?
> >  
> > That depends on where LBA48 is implemented.  If it's at the
> > controller level, I don't know what could be done.  If it's
> > a driver issue then NetBSD (since at least 1.6.2) should
> > not have a problem.
> > 
On http://www.cubeowner.com/forums/index.php?showtopic=11534&hl=netbsd
i read that it is a problem with the IDE firmware which is used for the
boot process to access the disk. So as far as NetBSD is concerned it
should be no problem at all because the bootloader is always located at
the beginning of the disk. Once the loader has started it is able
to access the whole drive as it doesn't depend on the IDE firmware.

Bye,

	Andre Schulze