NetBSD installed successfully, but can't load. Here is what I did on
my Apus 3000/C600

Installed succesfully NetBSD on the standard internal IDE drive
through the standard SCSI CD-ROM (Finally !! :-) )
selected to reboot as per asked vy the installer program.
since, I keep getting first "default catch" errors and after "claim
failed errors.

load-base & real-base are correct (I've re-set them a hundred times)
I'm using an ATI display card
I'm using the original ADB keyboard
I've retried to boot many times
- in one same open firmware session
- after reset-all commands
I've used both
- boot ata/ATA-Disk@0:0
- 0 boot ata/ATA-Disk@0:0 ofwboot.xcf

None seem to want to kick in the booting process.

I always get the same message when doing the first boot of an open
firmware session ::OF-open bootpath=AAPL,ROM
read stage 2 blocks : 01234567. done!
starting stage 2 ...
DEFAULT CATCH etc.

What am I doing wrong to get it booting?


		
__________________________________
Do you Yahoo!?
Yahoo! Mail is new and improved - Check it out!
http://promotions.yahoo.com/new_mail