I have a 266MHz model. Here's what I do:

* Boot into OF
* Type "setenv real-base F00000"
* Type "reset-all"
* Reboot back into OF
* Type "boot ide0/disk@0:0"

(Of course, you can set the boot string into OF, but I don't.)

Jeff Arenberg wrote:
> 
> I have a 233Mhz Desktop G3 running Open Firmware 2.0f1.  I've run SystemDisk
> and can get to the Open Firmware prompt.  I can boot from the floppy disk to
> NetBSD fine and I've run the install from a CD to a local HD on ide0.  I can
> run a shell from the floppy and mount the HD in BSD and all the files are
> present.  I've run installboot to the HD.  What I can't do is get the
> #$%^$#@ Mac to boot off the HD.  I've tried every combination device
> combinations I can think of.  I'm about ready to give up.  HELP!
> 
> (note if there's a way to boot from the floppy and then tell BSD to reload
> the kernal and run init from the HD without rebooting, or change the floppy
> to mount the HD during init, I'd take either of those solutions as well).
> 
> Thanks,
> Jeff

-- 
L. S.
+-+-+-+-+ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|l|.|s|.| |d|r|e|a|m|a|a|s|t|e|r|@|y|a|h|o|o|.|c|o|m|
+-+-+-+-+ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Don't let the smooth face fool ya.
:-| :-) ;-) :-)
*

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com