At 10:50 AM 12/18/2000 +0100, Manuel Bouyer wrote:
>On Sun, Dec 17, 2000 at 04:19:39PM -0600, Bob Nestor wrote:
> > Does anyone know if:
> >
> > The probe/interrupt problem with IDE0 is fixed in -current, and if so,
> > does anyone have a plans of posting a -current snapshot of it?
> >
> > My B&W G3 was able to probe and use IDE0 under 1.4.2 and 1.4K, but not
> > under 1.5.  I'd like to get -current running if possible so I can work on
> > Apple Partition Map support in sysinst over the Christmas Break.
>
>Is your IDE0 a PCI IDE controller ?

pciide0 at pci1 dev 1 function 0: CMD Technology PCI0646 (rev. 0x05)
pciide0: bus-master DMA support present
pciide0: primary channel configured to native-PCI mode
pciide0: using irq 26 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <IBM-DTTA-371440>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 13783 MB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 28229040 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (using DMA 
data transfers)
pciide0: secondary channel configured to native-PCI mode
pciide0: secondary channel ignored (disabled)

--
Matt Thomas               Internet:   matt@3am-software.com
3am Software Foundry      WWW URL:    http://www.3am-software.com/bio/matt/
Cupertino, CA             Disclaimer: I avow all knowledge of this message