Hello. I've been following the progress of the Mac port of NetBSD and had 
noticed it had gotten to run on a StarMax 3000/240, so I decided to give
a shot at installing it. The most recent kernel (Jul 29) provided the most
luck so far, given that I got somewhat of a device probe (the previous kernels
just hung after the kernel id message), and I'd thought I check to see if
anyone has any suggestions...

The firmware rev is 2.0.2, and this is using the console (have not succeeded 
in getting terminal off serial port to work). "load-base" was set to 100000, as
suggested by the linuxppc web site and past messages on this list. The machine
simply hangs after 'adb0' - for at least a week in one case... At the moment,
I am unable to compile any kernels for this platform :(

Any help would be appreciated.

-pjl


The kernel messages are:

NetBSD 1.3F (INSTALL) #0 : Wed Jul 29 12:51:49 JST 1998
    tsubai@kanea:/c/0725/src/sys/arch/macppc/compile/INSTALL
CPU: 603ev (revision 201)
real mem  = 33554432
avail mem = 24662016
using 800 buffers containing 3276800 bytes of memory
mainbus0 (root)
cpu0 at mainbus0
pci0 at mainbus0 bus 0
pci0: i/o enabled, memory enabled
pchb0 at pci0 dev 11 function 0
pchb0: vendor 0x106b product 0x001 (rev 0x03)
obio0 at pci0 dev 16 function 0: addr 0xf3000000
mesh at obio0 offset 0x10000 not configured
zsc0 at obio0 offset 0x13000: irq 15, 16
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
awacs at obio0 offset 0x14000 not configured
swim3 at obio0 offset 0x15000 not configured
nvram0 at obio0 offset 0x60000
ata at obio0 offset 0x20000 not configured
ata at obio0 offset 0x21000 not configured
adb0 at obio0 offset 0x16000 irq 18