Hi all,

I'm new to the world of NetBSD, so I apologize in advance for the newbie
question.

I've installed 1.4.1 on a IIvx with 20 megs RAM and a 230 meg HD.  The
swap partition is 40 megs, and the usr/root partition is ~190 megs.

The installation went quite smoothly, but now whenever I run certain
commands, vi and man, for instance, the following text appears anywhere
from three to dozens of times:

-----------BEGIN QUOTE-----------

Unexpected phase change.
scsi_show: scsi_main is not running
REQ-CONNECTED: 1 0x2490000[8192] cmd [0]=a S=0 M=ff R=0 resid=8192
	dr_flag=1
Bus signals (7c/00): I/OIC/DIMSGIREQISBY
Dma status: (30): IRQIEPAR
phase = 0, busy:2, spl:2204
	0	scsi_main4
	1	scsi_main5
	2	scsi_main1
	3	scsi_select1
	4	tpio1
	5	tpio2
	6	scsi_select10
	7	info_transf1
	8	tpio1
	9	tpio2
	10	info_transf5
	11	info_transf1
	12	info_transf3
	13	transfer_pdma0
	14	waiting for interrupt.
	15	scsi_main3
	16	scsi_main4
	17	scsi_main5
	18	drq (out)
	19	write complete
	20	read a byte to force a phase change
	21	end drq
	22	irq
	23	pdma_ready0
	24	pdma_ready1
Unexpected phase change

-----------END  QUOTE-----------       

Any ideas?  This seemed a little similar to the "Error on SCSIRead(),
#5" entry in the FAQ, but the partition is way under a gig.

Any help would be greatly appreciated.

 - Mathew