After a smooth first week of using 1.3.2 on my SE/30,
I locked up X, and had to use the programmer's switch
to restart.

The system still boots, and still seems to work, but there
is now a boot message which I do not recall seeing
before the forced restart:

  sd1: mode sense (4) returned nonsense: using
    fictitious geometry

I have installed 1.3.2 on scsi 1; I am using
kern (not kern_sbc) without difficulty so far on an
800 meg Quantum drive at that address.

Should I worry about this?  If so, can anyone
suggest a remedy?

Thanks!