Hi,
	I've succeeded in installing Current on the powerbook, but
it doesn't finish booting. It gets to the line:

boot on sd0a dumps on sd0b.

I have a 540c with 20 meg RAM, 810meg drive (IBM DVAS-2810 out of a
SPARCbook). 

The drive might be a little suspect. There is no termination on the drive,
so I have a SyQuest EZ 135 plugged into it (with or without cartridge doesn't
matter). 

The only errors I see are:
iwm: Initialization FAILED (-77)
probe(ncrscsi0:0:0): Unknown message 19. Rejecting.
probe(ncrscsi0:0:0): Unknown message f. Rejecting.


Is this more likely the disk not cooperating or the FPU emulation
problem? I can probably put the 330meg drive back in and install
on the SyQuest, for proof of concept. Any gotcha's there?

Suggestions?

Thanks,
Paul.

-- 
"The very best, and oldest, computer system built by man is Stonehenge.
 Built by the Druids, who didn`t die out, but went bankrupt trying to 
 debug the software."  --unknown