For what it's worth, I tried booting the GENERIC-100 kernel on my Performa 
636 (with real 68040), and the system locked up even before it cleared the 
screen.  I tried with both the 1.11.3 and 1.11.4a1 Booters, and verified that 
the previous kernel I had (GENERIC-95) booted with the same Booter config.  Is 
there anything different about this new kernel that requires different 
settings in the Booter or something?

	I guess my main curiosity on the new kernel was if the support for sn0 was 
any better.  Under GENERIC-95 if I try to boot off sn0 or ifconfig it once 
booted off a SCSI device, the system locks up hard (can't drop into the 
debugger or reboot with control-command-power).  I'd love to do some hacking 
with this box, but without ethernet or IDE it's kinda difficult..  =)

	Thanks in advance.


                                                          Will Ferry

-----------------
woferry@iname.com