Oooh... I hope there's a 1.2 sbc kernel - I'm still running 1.2. The 
point of this whole thing is for me to have a backup before I upgrade to 1.3!

-Capt Avram Dorfman
Chief, Network Operations
email: dorfman@pentagon.mil
(last resort email: avram@pobox.com)

:%s/\(do|-<\)/\1\1/g
:1,$d

On Mon, 5 Jan 1998, Coevoet Marc wrote:

> > 
> > I'm having a lot of problems. First, I keep getting:
> > 
> > 	tar: can't write to u1/u1.tar : Input/output error
> > 
> > When I try to tar into the new disk. It doesn't happen often, but often 
> > enough. Like 1 in 50 file writes fail this way.
> > 
> > Second, the console is spewing tons of these:
> > 
> > 	sd2(ncrscsi0:4:0) error code: 0
> > 
> > over and over again (much more often then the above error, possibly on 
> > every write).
> > 
> > Finally, and most imporant (looking anyway) is this, which I get during 
> > boot, and the first time I try to mount the disk:
> > 
> > 	sd2(ncrscsi0:4:0): illegal request, data= 33 90 01 32 c9 00 00 6d
> > 	b6 db 6d b6 db 6d b6 db 6d
> > 	
> > 	sd2: could not mode sense (4): using fictitious geometry
> 
> I had this too, use an sbc kernel.
> 
> Marc
> 
>