Re: Boot-time question

[Mouse <mouse%Rodents-Montreal.ORG@localhost>]

> hello.  I wonder if posting the dmesg from the successfully installed
> DT360 will give a clue?

Possibly, though I don't know how similar the DT360 and DT366 are.  See
below.

The DT360 battery is completely flat; even after being left on the
charger overnight, I can't see any delay from unplugging the charger to
the screen going black.  This is probably whence the "RTC BIOS
diagnostic error" line near the beginning and the "clock lost 3139
days" near the end.

uhub3 is external, in case that matters.  The device has only one
physical USB port, so a hub is necessary if I want to connect, say,
both a keyboard and a disk - or, in this case, a keyboard and an
Ethernet.  (I have few other bluetooth-capable devices, none of which
are set up enough to use that as a network transport.)

I'm going to see if I can kludge something together enough to capture
the boot-time messages from the DT366 in _some_ form.  (The boot
messages report finding COM ports, but, while there are some contacts I
don't know the semantics of, they are not a connector I recognize -
they look like bare PCB pads designed for a docking station.)

I'm going to try 5.2 on the DT366; overnight I left a job running to
copy 5.2 onto a thumb drive....

Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 4.0.1 (GEN401) #0: Mon Oct 19 08:41:48 EDT 2015
	mouse@:/home/mouse/kbuild/GEN401
total memory = 231 MB
rbus: rbus_min_start set to 0x40000000
avail memory = 216 MB
timecounter: Timecounters tick every 10.000 msec
RTC BIOS diagnostic error 44<ROM_cksum,invalid_time>
timecounter: Timecounter "i8254" frequency 1193182 Hz quality 100
BIOS32 rev. 0 found at 0xff880
mainbus0 (root)
cpu0 at mainbus0: (uniprocessor)
cpu0: AMD Geode LX (586-class), 498.08 MHz, id 0x5a2
cpu0: features 88a93d<FPU,DE,PSE,TSC,MSR,CX8,SEP>
cpu0: features 88a93d<PGE,CMOV,MPC,MMX>
cpu0: "Geode(TM) Integrated Processor by AMD PCS"
cpu0: I-cache 64 KB 32B/line 16-way, D-cache 64 KB 32B/line 16-way
cpu0: L2 cache 128 KB 32B/line 4-way
cpu0: ITLB 16 4 KB entries fully associative
cpu0: DTLB 16 4 KB entries fully associative
cpu0: 8 page colors
acpi0 at mainbus0: Advanced Configuration and Power Interface
acpi0: using Intel ACPI CA subsystem version 20060217
acpi0: X/RSDT: OemId <INSYDE,RSDT_000,31303030>, AslId <AMD ,31303030>
acpi0: SCI interrupting at int 9
acpi0: fixed-feature power button present
timecounter: Timecounter "ACPI-Safe" frequency 3579545 Hz quality 900
ACPI-Safe 32-bit timer
mpacpi: could not get bus number, assuming bus 0
LNKA: ACPI: Found matching pin for 0.1.INTA at func 1: 10
LNKB: ACPI: Found matching pin for 0.15.INTB at func 3: 11
LNKD: ACPI: Found matching pin for 0.15.INTD at func 4: 11
LNKA: ACPI: Found matching pin for 0.13.INTA at func 0: 10
ACPI Object Type 'Processor' (0x0c) at acpi0 not configured
ASIM0000 at acpi0 not configured
DTHIDBTN0 at acpi0 not configured
acpibat0 at acpi0 (PNP0C0A-1): ACPI Battery (Control Method)
acpibat1 at acpi0 (PNP0C0A-2): ACPI Battery (Control Method)
PNP0C0F [PCI interrupt link device] at acpi0 not configured
PNP0C0F [PCI interrupt link device] at acpi0 not configured
PNP0C0F [PCI interrupt link device] at acpi0 not configured
acpiacad0 at acpi0 (ACPI0003): ACPI AC Adapter
PNP0A03 [PCI/PCI-X Host Bridge] at acpi0 not configured
ACPILCD00 at acpi0 not configured
PNP0B00 [AT Real-Time Clock] at acpi0 not configured
attimer1 at acpi0 (PNP0100): AT Timer
attimer1: io 0x40-0x43,0x48-0x4b irq 0
pcppi1 at acpi0 (PNP0800)
pcppi1: io 0x61
pcppi1: children must have an explicit unit
midi0 at pcppi1: PC speaker (CPU-intensive output)
sysbeep0 at pcppi1
PNP0C01 [System Board] at acpi0 not configured
PNP0000 [AT Interrupt Controller] at acpi0 not configured
PNP0200 [AT DMA Controller] at acpi0 not configured
npx1 at acpi0 (PNP0C04)
npx1: io 0xf0-0xff irq 13
npx1: reported by CPUID; using exception 16
PNP0501 ACPI Error (nsxfeval-0216): Incorrect return type [Buffer] requested [String] [20060217]
[16550A-compatible COM port] at acpi0 not configured
PNP0501 ACPI Error (nsxfeval-0216): Incorrect return type [Buffer] requested [String] [20060217]
[16550A-compatible COM port] at acpi0 not configured
PNP0C01 [System Board] at acpi0 not configured
PNP0501 [16550A-compatible COM port] at acpi0 not configured
pcppi1: attached to attimer1
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
pchb0 at pci0 dev 1 function 0
pchb0: Advanced Micro Devices Geode LX Host-PCI Bridge (rev. 0x31)
vga1 at pci0 dev 1 function 1: Advanced Micro Devices Geode LX VGA Controller (rev. 0x00)
wsdisplay0 at vga1 kbdmux 1: console (80x25, mterm emulation)
wsmux1: connecting to wsdisplay0
glxsb0 at pci0 dev 1 function 2: RNG AES
cbb0 at pci0 dev 13 function 0: Texas Instruments PCI1520 PCI-CardBus Bridge (rev. 0x01)
cbb1 at pci0 dev 13 function 1: Texas Instruments PCI1520 PCI-CardBus Bridge (rev. 0x01)
pcib0 at pci0 dev 15 function 0
pcib0: Advanced Micro Devices CS5536 PCI-ISA Bridge (rev. 0x03)
viaide0 at pci0 dev 15 function 2
viaide0: Advanced Micro Devices CS5536 IDE Controller (rev. 0x01)
viaide0: bus-master DMA support present
viaide0: primary channel wired to compatibility mode
viaide0: primary channel interrupting at irq 14
atabus0 at viaide0 channel 0
viaide0: secondary channel wired to compatibility mode
viaide0: secondary channel ignored (disabled)
Advanced Micro Devices product 0x2093 (audio multimedia, revision 0x01) at pci0 dev 15 function 3 not configured
ohci0 at pci0 dev 15 function 4: Advanced Micro Devices CS5536 OHCI USB Controller (rev. 0x02)
ohci0: interrupting at irq 11
ohci0: OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: Advanced Micro OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 4 ports with 4 removable, self powered
ehci0 at pci0 dev 15 function 5: Advanced Micro Devices CS5536 EHCI USB Controller (rev. 0x02)
ehci0: interrupting at irq 11
ehci0: BIOS has given up ownership
ehci0: EHCI version 1.0
ehci0: companion controller, 4 ports each: ohci0
usb1 at ehci0: USB revision 2.0
uhub1 at usb1
uhub1: Advanced Micro Devices EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub1: 4 ports with 4 removable, self powered
cbb0: interrupting at irq 10
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1
pcmcia0 at cardslot0
cbb1: interrupting at irq 10
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 2
pcmcia1 at cardslot1
isa0 at pcib0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
com2 at isa0 port 0x3e8-0x3ef irq 5: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
pckbport_cmd: send error
pckbd0 at pckbc0 (kbd slot)
pckbport_cmd: send error
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
kbc: aux echo error 1
kbc: cmd word write error
isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
isapnp0: no ISA Plug 'n Play devices found
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
Kernelized RAIDframe activated
uhub2 at uhub1 port 1
uhub2: Standard Microsystems product 0x2504, class 9/0, rev 2.00/0.01, addr 2
uhub2: multiple transaction translators
uhub2: 4 ports with 4 removable, self powered
ugen0 at uhub2 port 2
ugen0: VIA Networking Technologies, Inc. VNT USB-802.11 Wireless LAN Adapter, rev 2.00/2.05, addr 3
wd0 at atabus0 drive 0: < 512MB ATA Flash Disk>
wd0: drive supports 1-sector PIO transfers, LBA addressing
wd0: 488 MB, 993 cyl, 16 head, 63 sec, 512 bytes/sect x 1000944 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2
wd0(viaide0:0:0): using PIO mode 4, DMA mode 2 (using DMA)
ubt0 at uhub0 port 2 configuration 1 interface 0
ubt0: Cambridge Silicon Radio Bluetooth USB Adapter, rev 2.00/17.66, addr 2
uhub3 at uhub1 port 3
uhub3: vendor 0x1a40 USB 2.0 Hub, class 9/0, rev 2.00/1.11, addr 4
uhub3: single transaction translator
uhub3: 4 ports with 4 removable, self powered
uhidev0 at uhub3 port 3 configuration 1 interface 0
uhidev0: CHESEN USB Keyboard, rev 1.10/1.10, addr 5, iclass 3/1
ukbd0 at uhidev0
wskbd1 at ukbd0 mux 1
wskbd1: connecting to wsdisplay0
uhidev1 at uhub3 port 3 configuration 1 interface 1
uhidev1: CHESEN USB Keyboard, rev 1.10/1.10, addr 5, iclass 3/0
uhidev1: 3 report ids
ums0 at uhidev1 reportid 1: 3 buttons and Z dir.
wsmouse0 at ums0 mux 0
uhid0 at uhidev1 reportid 2: input=1, output=0, feature=0
uhid1 at uhidev1 reportid 3: input=3, output=0, feature=0
cue0 at uhub3 port 4
cue0: CATC CATC NetMate2 Ethernet Adaptor, rev 1.00/2.00, addr 6
cue0: Ethernet address 00:30:db:00:44:98
RF autoconfig: raw component list: .
RF autoconfig: sets: .
RF autoconfig: parts-missing list: .
RF autoconfig: dropping unconfigurable list: .
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
WARNING: clock lost 3139 days
WARNING: using filesystem time
WARNING: CHECK AND RESET THE DATE!

/~\ The ASCII				  Mouse
\ / Ribbon Campaign
 X  Against HTML		mouse%rodents-montreal.org@localhost
/ \ Email!	     7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B