Subject: Net4801 probe
To: None <port-i386@netbsd.org>
From: None <itojun@iijlab.net>
List: port-i386
Date: 08/18/2003 23:54:40
	here's openbsd's dmesg.  it apparently touches function 1 of
	SC1100 device, but does not panic like netbsd does.

>"NS SC1100 SMI/ACPI" rev 0x00 at pci0 dev 18 function 1 not configured

itojun

------- Forwarded Message

POST: 0123456789bcefghipajklnoq,,,tvwxy2J
comBIOS ver. 1.20  20030721  Copyright (C) 2000-2003 Soekris Engineering.

net4801

0128 Mbyte Memory			 CPU Geode 266 Mhz

Pri Mas	 SanDisk SDCFB-128		 LBA 980-8-32  125 Mbyte

PXE-M00: BootManage UNDI, PXE-2.0 (build 082)

Slot   Vend Dev	 ClassRev Cmd  Stat CL LT HT  Base1    Base2   Int
- -------------------------------------------------------------------
0:00:0 1078 0001 06000000 0107 0280 00 1F 00 00000000 00000000 00
0:06:0 100B 0020 02000000 0107 0290 00 3F 00 0000E101 A0000000 10
0:07:0 100B 0020 02000000 0107 0290 00 3F 00 0000E201 A0001000 10
0:08:0 100B 0020 02000000 0107 0290 00 3F 00 0000E301 A0002000 10
0:18:2 100B 0502 01018001 0005 0280 00 00 00 00000000 00000000 00
0:19:0 0E11 A0F8 0C031008 0117 0280 08 38 00 A0003000 00000000 11

 4 Seconds to automatic boot.	Press Ctrl-P for entering Monitor.
Using Drive: 0 Partition: 3
reading boot.....
probing: pc0 com0 com1 pci mem[639K 63M a20=on]
disk: hd0+
>> OpenBSD/i386 BOOT 2.01
switching console to com0
com0: changing speed to 19200 baud
com0: change your terminal to match!
com0: will change speed in 5 seconds....

com0: console is at 19200 baud
boot> generic -a
booting hd0a:generic: 4460884+837564/[67+202528+180155]=0x56b1f4
entry point at 0x100120

[ using 383204 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 3.3-current (GENERIC) #24: Thu Jul 31 18:20:20 CEST 2003
    markus@folly:/home/openbsd/src/sys/arch/i386/compile/GENERIC
cpu0: National Semiconductor Geode GX1 ("Geode by NSC" 586-class) 267 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
real mem  = 66695168 (65132K)
avail mem = 55984128 (54672K)
using 839 buffers containing 3436544 bytes (3356K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 20/30/21, BIOS32 rev. 0 @ 0xf7840
pcibios0 at bios0: rev. 2.0 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc8000/0xa000
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm Host-PCI" rev 0x00
sis0 at pci0 dev 6 function 0 "NS DP83815 10/100" rev 0x00: irq 10 address 00:00:24:c1:34:14
nsphyter0 at sis0 phy 0: DP83815 10/100 integrated, rev. 1
sis1 at pci0 dev 7 function 0 "NS DP83815 10/100" rev 0x00: irq 10 address 00:00:24:c1:34:15
nsphyter1 at sis1 phy 0: DP83815 10/100 integrated, rev. 1
sis2 at pci0 dev 8 function 0 "NS DP83815 10/100" rev 0x00: irq 10 address 00:00:24:c1:34:16
nsphyter2 at sis2 phy 0: DP83815 10/100 integrated, rev. 1
pcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00
"NS SC1100 SMI/ACPI" rev 0x00 at pci0 dev 18 function 1 not configured
pciide0 at pci0 dev 18 function 2 "NS SC1x00 IDE" rev 0x01: DMA (unsupported), channel 0 wired to compatibility, channel 1 wired to compatibility
pciide0: channel 0 ignored (other hardware responding at addresses)
pciide0: channel 1 ignored (not responding; disabled or no drives?)
"NS SC1100 X-Bus" rev 0x00 at pci0 dev 18 function 5 not configured
ohci0 at pci0 dev 19 function 0 "Compaq USB OpenHost" rev 0x08: interrupting at irq 11, OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: Compaq OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
wdc0 at isa0 port 0x1f0/8 irq 14
wd0 at wdc0 channel 0 drive 0: <SanDisk SDCFB-128>
wd0: 1-sector PIO, LBA, 122MB, 980 cyl, 8 head, 32 sec, 250880 sectors
wd0(wdc0:0:0): using BIOS timings
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
biomask 4800 netmask 4c00 ttymask 4c02
pctr: user-level cycle counter enabled
dkcsum: wd0 matched BIOS disk 80
root device?
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
warning: /dev/console does not exist
init: not found
panic: no init
Stopped at	Debugger+0x4:	leave
RUN AT LEAST 'trace' AND 'ps' AND INCLUDE OUTPUT WHEN REPORTING THIS PANIC!
DO NOT EVEN BOTHER REPORTING THIS WITHOUT INCLUDING THAT INFORMATION!
ddb>

------- End of Forwarded Message