--==_Exmh_-413573496P
Content-Type: text/plain; charset=us-ascii

On Tue, 25 Aug 1998 08:08:18 +0200, Stefan Grefen says
>You can try:
>    options         PCIC_ISA_ALLOC_IOBASE=0x400
>    options         PCIC_ISA_ALLOC_IOSIZE=0xbff
>
>This gets you out of most conflicts and should work on most systems.
>If NetBSD trys to set you to 0x330 then the above should work, if it 
>goes for 0x300 it won't work.

Nope, same problem.  The first two octets of the MAC address are still
wrong.  I wonder if 3Com is trying to save a few bytes, since really only
the last 4 octets differ between their cards.  Doesn't seem worth the
bother, though.

The boot messages, BTW, are:
pcmcia1 at pcic0 controller 0 socket 1
pcmcia1: CIS version 2.0 or 2.01
pcmcia1: CIS info: 3Com Corporation, 3C589D, TP/BNC LAN Card Ver. 2a, 000002
pcmcia1: Manufacturer code 0x101, product 0x589
pcmcia1: function 0: network adapter, ccr addr 10000 mask 3
pcmcia1: function 0, config table entry 1: I/O card; irq mask ffff; iomask 4, io
space 0-f; rdybsy_active wp_active bvd_active io8 io16 irqlevel
pcmcia1: function 0, config table entry 3: I/O card; irq mask ffff; iomask 4, io
space 0-f; rdybsy_active wp_active bvd_active io8 io16 irqlevel
ep1 at pcmcia1 function 0 port 0x350-0x35f: 3Com 3C589 Ethernet
ep1: MAC address ff:fc:4b:a0:36:ca
ep1: 8KB byte-wide FIFO, 5:3 Rx:Tx split, utp/aui/bnc (default utp)

Can anyone point me at a location in the 1.3.2 source where I could
hard-code the MAC address, just so I can get this working?  I tried in 
/sys/dev/pcmcia/if_ep_pcmcia.c but failed.

	-Kevin



--==_Exmh_-413573496P
Content-Type: application/pgp-signature

-----BEGIN PGP MESSAGE-----
Version: 2.6.2

iQCVAwUBNeLEAX4qeMKIUCpVAQH7BwP/eODBQELCq0FQtqGwINA/9GosbxyMY8By
jW9i9EwNRaE5ZhnR2rFOtxrZ0K7JExl+sG1EEXRtil8eqp9CY9zb3MQbq2oJ25BD
Oztsb+SA/+5FdHY56G36NviVAxusGoBn210iCHgguVSIRgs4sGcmktUg5KuoOZGJ
BHOyFWMpRpk=
=2Hym
-----END PGP MESSAGE-----

--==_Exmh_-413573496P--